How To Shock Worms With 12 Volt Battery

Worms are one of the nigh pop options of alive allurement used by fisherman. Worms can be used to induce several species of fish to seize with teeth your hook. Yous tin purchase packages of worms at your local bait shop, but you can salvage money during fishing flavor by building your own electric worm probe. An electric worm probe will allow you lot to harvest worms right from the ground and avert paying for a new parcel of worms each fourth dimension you go fishing.

Items you will demand

• 4 feet of insulated, unmarried-strand electric wire

• Wire cutter

• Wire stripper

• 2 plastic-handled screwdrivers

• 6-volt lantern battery

• Electric tape

Step 1

Cut the electrical wire into two equal 2-foot pieces using your wire cutter.

Stride 2

Strip v to 6 inches of plastic insulation off one end of each piece of wire using your wire stripper.

Step 3

Wrap the stripped finish of 1 slice of wire around the metal portion of i screwdriver until you reach the plastic insulation. Echo for the second wire and screwdriver.

Step iv

Use your wire stripper to remove two to three inches of plastic insulation from the wire ends that are not connected to the screwdrivers.

Footstep 5

Wrap i of the exposed wire ends around the positive (+) node on your 6-volt bombardment. Wrap the other wire around the negative (-) battery node. The nodes on the battery look like to conical bed springs.

Stride vi

Cover the nodes and wires continued to the bombardment with electric record.

Step 7

Insert the screwdrivers into the soil about two anxiety apart. The bombardment will send a low-level electrical current through the ground and worms will begin to announced on the surface for you to harvest.

Warnings

• Always concord the screwdrivers by the plastic handles, even though the voltage used in this method is minimal and much safer than using higher levels of electricity such as household outlets.

Tips

• For better results, use the worm probe after a long rain or use a sprinkler to moisture the footing. This volition bring the worms closer to the surface and allow yous to harvest more worms in less time.
• Once you accept connected the wires to the bombardment nodes, an electric electric current will run through the screwdrivers. Test the connection by touching the ends of the screwdrivers together. Y'all should see a small spark if the connection has been washed correctly.

Tips

• For better results, use the worm probe after a long rain or use a sprinkler to wet the basis. This will bring the worms closer to the surface and allow you to harvest more worms in less time.
• One time you lot accept connected the wires to the battery nodes, an electric electric current will run through the screwdrivers. Test the connexion by touching the ends of the screwdrivers together. You lot should see a small-scale spark if the connexion has been done correctly.

Warnings

• Always hold the screwdrivers by the plastic handles, even though the voltage used in this method is minimal and much safer than using higher levels of electricity such every bit household outlets.

Writer Bio

Greg Stewart has been writing online copy since the beginning of 2009. He runs several blogs hosted on Wordpress and contributes to several online marketing campaigns for companies such as RingJohn. He has a B.A. in marketing and economics and is TEFL certified.

Source: https://goneoutdoors.com/make-electric-worm-probe-6565579.html

Share this post